DIGI PROT
DIGI PROT offers the most comprehensive parameter monitoring on the market, with all parameters controlled electronically by latest-generation microprocessors.
Critical parameters such as temperature, pressure and voltage are monitored while corrective actions are applied, such as stopping the engine whenever values rise above or fall below the previously programmed normal ranges. In the same way, it also monitors excess RPM and speed (the only unit that monitors these parameters).
Installer? Software and technical diagrams are available in the installer portal
General features
- Sensors
- They do not require drilling the cylinder head or any other original part of the vehicle, so neither its operation nor its original warranty is compromised.
- Operating indications
- The unit gives a light and sound signal depending on the operating condition detected at the time. See the documentation for further details.
Special features
Directly monitored parameters
Maximum and minimum RPM.
Maximum and minimum temperature of the engine block and of the radiator or gearbox.
Maximum and minimum voltage. Battery overcharge or discharge, respectively.
Low oil pressure (monitored from the vehicle's original sensor).
Fault indication
The unit self-checks its own sensors, raising an alarm if any of them fails. If the protector is triggered by one or more of the causes listed above, the engine will be stopped after 15 seconds (this time is programmable), although before the 15 seconds are up the driver can press the reset button to extend the time so the vehicle can pull over and park.